Inground Pool Pump

Hayward 2.5HP In/Above Ground Swimming Pool Pump Motor Strainer Generic 110V

Hayward 2.5HP In/Above Ground Swimming Pool Pump Motor Strainer Generic 110V
Hayward 2.5HP In/Above Ground Swimming Pool Pump Motor Strainer Generic 110V
Hayward 2.5HP In/Above Ground Swimming Pool Pump Motor Strainer Generic 110V
Hayward 2.5HP In/Above Ground Swimming Pool Pump Motor Strainer Generic 110V
Hayward 2.5HP In/Above Ground Swimming Pool Pump Motor Strainer Generic 110V
Hayward 2.5HP In/Above Ground Swimming Pool Pump Motor Strainer Generic 110V
Hayward 2.5HP In/Above Ground Swimming Pool Pump Motor Strainer Generic 110V
Hayward 2.5HP In/Above Ground Swimming Pool Pump Motor Strainer Generic 110V
Hayward 2.5HP In/Above Ground Swimming Pool Pump Motor Strainer Generic 110V
Hayward 2.5HP In/Above Ground Swimming Pool Pump Motor Strainer Generic 110V
Hayward 2.5HP In/Above Ground Swimming Pool Pump Motor Strainer Generic 110V
Hayward 2.5HP In/Above Ground Swimming Pool Pump Motor Strainer Generic 110V

Hayward 2.5HP In/Above Ground Swimming Pool Pump Motor Strainer Generic 110V
Maintain a crystal clear and sparkling pool or spa that everybody loves with the new SPPE series self-priming 1850W electric swimming pool pump. Locate the pump as close as possible to the pool.

The pump suction line should not be smaller than the pressure line. All piping must be airtight 3.

The threads on the pump must be sealed with Teflon Tape or Silicon, when the pump unions are screwed on. The weight of the piping should be supported independently and not carried by the pump.

Fill the pump tank with water before starting. High suction lifts, or long suction lines, require additional time and reduce the performance of the pump.

The water being pumped cools and lubricates the seal. After the pump tank has been filled with water, and the motot started, allow a few moments for the pump to start delivering water. The installation must be according to the normal power indicated on the label. The amperage must not at any time exceed the value indicated on the label It is recommended that you consult a state-registered electrician. Place the pump in a dry area with good ventilation.

The ambient temperature must not exceed 40? The pumps are only suitable for counter-clockwise rotation when viewing from the pump end. Three phase motors can rotate in either direction.

Interchanging any of the cables on a three-phase motor will reverse the rotation. Momentarily start, or bump the motor without water in the tank, to check the rotation of the pump shaft. Before disconnecting electrical connections, shut off electricity at its source. Newer work on pump without making certain the power is OFF. This appliance is not intended for use by persons, including children with reduced physical, sensory or mental capabilities or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a responsible for their safety Children should be supervised to ensure that they do not play with the appliance.

Head : Max 19m / 62.34ft. Pipe Compatibility : Fit 1.5 inch plumbing internally. Weight : 10.2 kg / 22.5 lbs. 1 x SPPE250 Swimming Pool Pump.

1 x User's Manual. Powerful Self-Priming IP55 2.5HP Electric Motor, low noise with quiet operation and no leak. Suitable for pools up to 100,000 litres. Advanced S-Tek Flow System For Increased Efficiency With Continuous Flow Rate Of 560L/min.

Full Size Removable Strainer Basket. 100% Salt and Chlorine compatible. Full Commercial Duty - Designed to run 24/7. Works with In ground and Above Ground. Ideal for Residential/Commercial Swimming Pools & Spa's.

Please contact our customer service team immediately if: 1. You changed your mind and wish to request a return. Your product was damaged during transit. Please do not return or post items before obtaining instructions from us.

This also applies to orders cancelled while in transit. Please make sure that item has NO man-made sabotage.

Used items will not be accepted for return. We will require a picture of the damaged part for verification. The item "Hayward 2.5HP In/Above Ground Swimming Pool Pump Motor Strainer Generic 110V" is in sale since Saturday, February 20, 2021.

This item is in the category "Home & Garden\Yard, Garden & Outdoor Living\Pools & Spas\Pool Equipment & Parts\Pool Pumps". The seller is "fansdealonline" and is located in Westbury, New York. This item can be shipped to United States.

  • Brand: FANSDEALONLINE
  • Type: Pool Pump
  • Voltage: 110 V
  • Pool Type: In Ground &Above Ground
  • Motor Shaft Material: Stainless Steel
  • Pump Housing Material: PPGF30 + PC (anti-Oxident)
  • Rated Power: 1850W/2.5HP
  • Color: Black
  • Amper: 16A
  • Horsepower: 2.5HP
  • Speed: Single-Speed
  • Qmax: 560 L/min
  • Hmax: 21 Meter
  • Frequency: 60HZ
  • Max.

    Temp: 104 Degree Fahrenheit (40 Degree Celsius)

  • Power Cord: 59"
  • Certification: UL Certification
  • Warranty: 5 Years
  • Suitable For: Above Ground Pools
  • Manufacturer Warranty: 5 years
  • Power: 1850w
  • Pipe Compatibility: Fit 1.5 inch plumbing internally
  • Power Source: Corded
  • Features: Easy Assembly
  • Installation: Universal Installation
  • Material: ABS
  • Item Width: 6.9"
  • Item Height: 6.9"
  • Item Length: 22.4"
  • Item Weight: 30 lb
  • Amperage: 16A


Hayward 2.5HP In/Above Ground Swimming Pool Pump Motor Strainer Generic 110V