13 Sand Filter with 3/4HP Water Pump Above Ground Swimming Pool with Stand
Anbull 13 inch Sand Filter Pump. Above ground pool pump and filter system working principle. #20 quartz sand of 0.4-0.8? When filtering, (if you use quartz sand less than 0.4-0.8?
, it will cause the sand to enter the swimming pool with water during filtration). In addition, our sand filter pump. Is only suitable for swimming pools of about 24 cubic meters. If your pool is more than 24 cubic meters, please choose a sand filter pump with more horsepower.The pump(the filter pipe of the transparent cover). Must be filled with water.
Before it can be turn on and run. It will cause dry grinding of the mechanical seal and case heat generation to damage the impeller and bearing, and. Finally cause the water pump to leaking and high noise.
Incoming water from the piping system is automatically directed by the Mulitiport Valve tothe top of the filter bed, as. The water is pumped through the filter sand, dirt and debris are trapped by the filter bed, and filtered out. It is a sand filter pump for above ground pool.
Also use for regalar vacuuming. When filter rpressere gauge rises 8-10 PSI (0.55-0.69 BAR) above start-up(clean pressure).
Stop the pump, set valve to. Start pump and backwash until water in sight glass is clear.
Approximately 2 minutes or less depending on dirt accumalation. With pump off, set vavle to. Start pump and operate for about 1/2 to 1 minute. This ensures that all dirty water from backwashing is rinsed out of the filter to waste, preventiong possible return to the ump. And start pump for nomal filtering. To by pass filter for draining or lowering water level an dfor vacuuming heavy debris directly to waste. Connector: 1-1/4" or 1-1/2"NPT union, Connecting hose. Make sure the sand filter pump is worked under the work pressure, and using a pressure control vavle when the system using a booster pump. If the pump position is higher than the water level, it requires to install the back water control vavle. If the pump position is lower than the water level, it requires installing an isolation valve, it could stop the water retuen back when people do the general inspection. Reducing the connect adaptors and hose connecting bending as less as possible. Decreasing the water flow scrub, it could reach the maximum effective. About the details of the Anbull sand filter pump.3/4 HP(550W) swimming pool pump1. Filter tube and filter tube base 1. Clamp assembly 1 (clamp 2;Screw nut2).
Flow rate: 3648 gallons per hour. Granularity: 31''-472''/-0.8-12mm. Max flow rate: 18m³/h(4755gal/h). Polyethylene blow molding tank, anti-aging; large capacity can hold 42LB/19KG quartz sand. Low noise design, more comfortable work and more energy-saving. Easy to use-four-way valve, three-hole plug with cable, portable, quick start, simple operation. Multi-port filter-multi-port provides easy-to-use and fast backwashing function.